![background image](http://html1.mh-extra.com/html/xyz-machine-tools/trak-2op-m11-mill/trak-2op-m11-mill_safety-installation-maintenance-service-and-parts-list_3848763107.webp)
103
XYZ Machine Tools Ltd
TRAK
2
OP
Installation, Maintenance, Service & Part List Manual
6.7
Ballscrew Replacement, Z Axis
DANGER!
During the removal and replacement procedures it is often necessary to jog the axes to gain access to
various parts of the machine. To minimise the risk of serious injury through crushing, you must
power
down or E-stop the machine each time you access the inside of the machine.
Ensure unauthorised personnel are kept away from the machine when you are working
inside.
Please refer to assembly drawing 27540-1 found at the back of this manual.
1.
Remove the side enclosure covers A & B from the machine enclosure. See figure 6.7a.
Figure 6.7a
2.
Jog the Z-axis to its full upward position.
3.
Remove the ATC door by removing the four SHCS that secure the door flange to the column (at D
and E, fig 6.7a). Disconnect the door from the air cylinder at the pivot bolt. See figure 6.7b.
Figure 6.7b
4.
Remove the Z-axis ballscrew cover C (figure 6.7a).
Summary of Contents for TRAK 2OP M11 Mill
