XYZ Machine Tools TRAK 2OP M11 Mill, Safety, Installation, Maintenance, Service And Parts List

Page: 52 / 203

48
XYZ Machine Tools Ltd
TRAK  2
OP
Installation, Maintenance, Service & Part List Manual
4. Handwheel port: Interface to the electronic handwheel (MPG), power and encoder feedback
5. Spindle Port Interface to the spindle drive.
6. VGA port: Video signal for the LCD.
7. COM port: Serial port used to communicate to the Overlay Interface board. If the
Programming panel keys are not operating correctly this cable may be at
fault.
8. Machine ID port: Machine ID key plugged in here to identify the machine type to the
software. For Euro 2-OP mill, machine ID is 123.
9. USB port: USB 2.0 compatible USB port, extended by 2 cables to the front of the
machine.
10. Network Port: A network cable runs from this port to the top of the machine at the right
side. This allows users to network the control.
Figure 5.3a – Computer module Front View