92
XYZ Machine Tools Ltd
TRAK
2
OP
Installation, Maintenance, Service & Part List Manual
16.
Reset the E-stop and go to Service Code 505
17.
Check the Index Angle by jogging the ‘X” axis slowly off and then back onto the home switch. See
figure 6.1.1d.
18.
Note the Index Angle and adjust if necessary. In the example here, the index angle is 179° for the
X axis; the specification is 180° ±45°.
Figure 6.1.1d
19.
“Home” the machine.
20.
Go to Service Code 520 and set tool locations for all eight tools. Then go to Service Code 500 and
set the “X” and “Y” locations.
21.
Reinstall all covers.
6.1.2
Y-axis servo motor replacement
Please refer to assembly drawing 27564-1 found at the back of this manual.
Removal of the Y Motor
1.
If the machine can be jogged under power, go to Service Code 505 and jog the “Y” axis forward
(use the finest resolution when you get near the limit switch) until the “POS Y AXIS LIMIT SWITCH”
flashing warning message appears (as in figure 6.1.1d, but for the Y axis).
2.
If the machine cannot be jogged under power, it will be necessary to move the axis manually.
3.
Monitor the Y axis home switch in the INPUTS screen of Service Code 521. Manually turn the “Y”
axis ball screw to move the axis far to the right until the “Y” Axis Home” box check mark appears.
4.
Power down the machine.
5.
Locate the Y-axis servo motor at the lower rear section of the 2 Op Mill. Disconnect the encoder
and power cables from the machine. See figure 6.1.2.
6.
Loosen the four SHCS that attach the motor to the machine. Note: The lower screws fit into “Slots”
on the motor mount casting. Remove the upper screws and lift out the motor and belt.
Summary of Contents for TRAK 2OP M11 Mill
