![background image](http://html1.mh-extra.com/html/xyz-machine-tools/trak-2op-m11-mill/trak-2op-m11-mill_safety-installation-maintenance-service-and-parts-list_3848763088.webp)
84
XYZ Machine Tools Ltd
TRAK
2
OP
Installation, Maintenance, Service & Part List Manual
counts. The DRO will display counts unaffected from calibration compensation. The Z axis cannot be
checked with this service code.
5.11.3.4
CODE 132: Electronic Handwheel Test
This service code can be used to troubleshoot any issues seen with the electronic handwheel. Simply turn
the handwheel in either direction while in this screen, and the display should increment 1 count per click,
100 counts per revolution.
5.11.3.5
Code 319: Message Log
This service code captures data as the machine runs, including key presses, error messages and commands
sent to the motion control system. This is the key piece of information we request when dealing with a
potential software problem. Note: it is prefered to save this file using service code 1 as this service code
also saves other useful diagnostic information.
You can navigate the log via the PAGE FWD and PAGE BACK soft keys on the screen. Use the EHW to scroll
through the file one line at a time. The DATA BOTTOM key takes you to the bottom of the file and then
changes to data top which will take you back to the top. If you press MORE, you can turn the log on and
off, the default is on. The log should not be turned off. The message log file will capture data up to a point
and then the file is saved to a backup file and the original file is cleared and data is once again captured.
There is also a clear log file, which is useful if you have a problem that you can duplicate. It is nice to clear
the file and then run your program to capture just the information that pertains to the problem. From here
the user can save the 2 files to a USB flash drive. Once this is done it prompts you to save the files
individually. Again, it is better to run service code 1 to capture the logs.
Lastly, there is another MORE button on the 2nd page of the message log. This allows the user to change
the logging capabilities. The log leaves the factory with the following settings. These should not be
changes unless specifically requested by an XYZ representative. Turning on logging features that are off
may have a negative impact on the motion control system.
5.11.3.6
Code 326: Error Message Display
Displays the content of an error message, where the error number is already known.
Summary of Contents for TRAK 2OP M11 Mill
