Xerox Versant 4100 Press, User Documentation

Page: 94 / 430

SSeettttiinngg U Upp M Meeddiiaa iinn tthhee SSttoocckk W Wiizzaarrdd
You can set up the media or stock in the Stock Wizard with or without a barcode. Refer to:
• Setting Up Media with a Barcode in the Stock Wizard
• Setting Up Media without a Barcode in the Stock Wizard
• Setting Up Media with a Custom Barcode in Offline Mode
Setting Up Media with a Barcode in the Stock Wizard
1. On the Stock Wizard Setup screen, select the paper orientation:
• Long Edge Feed
• Short Edge Feed
2. Click Next .
3. The Stock Wizard performs the recommended automatic setup routines. After each setup, click
Accept and Next . The automatic setup routines include:
• Tray Programming
• Basic Alignment Setup
•
Secondary Transfer Voltage Adjustment
•
Calibration and Profiling
: This automatic setup is performed after the semi-automatic
adjustments, and before any manual adjustments. For more information, refer to Calibration
and Profiling .
Note: It is important to remember that these setup routines and all of the other print
engine adjustments are performed only if needed. If the PredictPrint Cloud Server
Intelligence determines that they are not needed, the PredictPrint Stock Wizard skips them.
4. At any time during the process, to change the information on the previous screen, click Go Back .
5. At any time during the process, to cancel the stock setup routines, click Cancel Setup .
Note: The Cancel Setup option stops any additional setup routines from running in the
wizard, at that time. Cancelling setup routines does not cancel the assignment of the stock
to the tray.
6. To go to the next setup routine, click Accept and Next .
Setting Up Media without a Barcode in the Stock Wizard
To get a barcode for the media, ensure that the tray is loaded with the stock for which you need a
barcode.
1. On the Stock Wizard Setup screen, select the paper orientation:
• Long Edge Feed
• Short Edge Feed
2. Click Next .
A barcode appears on the next screen.
94 Xerox ® Versant ® 4100 Press
User Documentation
Working With