• The
Secondary Transfer Voltage Adjustment
procedure can be performed by selecting
Auto
or
Manual
.
Note:
An automatic adjustment fixes most image quality issues. Always perform the
Auto
procedure before performing the
Manual
adjustment.
–
Auto
: The adjustment is done automatically by the press. It eliminates the need for you to
interpret printed targets and enter adjustment values manually. This saves time and
avoids errors.
–
Manual
: The user must manually perform the adjustment, including printing test patterns,
interpreting the printed targets on those patterns, and then manually entering the
adjustment values.
Tip:
Use the
Manual
adjustment option only when the
Auto
adjustment does
not provide the desired output.
–
For detailed information and instructions on using the
Auto
and
Manual
adjustment
options, refer to
Secondary Transfer Voltage Adjustment
.
2. If the issue is observed on the tail edge of the printed output and is not corrected by performing a
Secondary Transfer Voltage Adjustment
, change the
Transfer Output Adjustment for Trail
Edge
setting.
• Use this feature to adjust the voltage ratio on the secondary bias transfer roll (2
nd
BTR); this is
where the image is transferred from the belt to the paper.
• This feature is accessed from
PredictPrint Media Manager
→
Stock Library
→
Stock
Properties
→
Advanced Setup
→
Transfer Output Adjustment for Trail Edge
.
• Decrease the
Transfer Output Adjustment for Trail Edge
in increments of 10%. After every
incremental adjustment, run test prints and evaluate the output to determine if additional
adjustment is necessary.
3. Perform an
Automatic Density Uniformity Adjustment
.
Note:
This is a press feature and is not a
PredictPrint Media Manager
feature.
• Use this feature to correct image quality issues on the output when that image quality is not
consistent throughout the entire output. For example, the image quality is lighter or faded or it
is heavier or thicker on the left or right sides of the output, inboard or outboard.
• For information and instructions on how to use this feature, refer to
IIm
maaggee RReeggiissttrraattiioonn,, PPeerrppeennddiiccuullaarriittyy,, SSkkeew
w,, aanndd
M
Maaggnniiffiiccaattiioonn
Problem
The image on the printed output is misregistered, or is perpendicular, skewed, or magnified.
For information, refer to
.
308
Xerox
®
Versant
®
4100 Press
User Documentation
Summary of Contents for Versant 4100 Press
