Xerox Versant 4100 Press, User Documentation

Page: 182 / 430

1. Printed Media from the Press
2. Interface Decurler Module paper path
3. Printed media from the Interface Decurler
Module to inline finishing device
As media enters the module, it is fed to the IDM decurler for paper curl correction. The IDM decurler
has both upper and lower decurler rolls that apply pressure to the media based upon the following:
• System default ( Auto on)
• Manual selections made from the IDM control panel
If you want to adjust the paper curl on the printed output quickly and at the point-of-need, use the
manual curl up or down buttons. If the printed output contains too much curl after using these
buttons, refer to
Advanced Stock Setup and Correcting the Paper Curl .
From the IDM decurler, the print media is cooled and routed from the IDM to the optional finishing
device that is next inline and connected to the press.
Curl Correction Modes and Functions on the Interface Decurler Module
Note: When an Interface Decurler Module (IDM) curl correction mode is selected, the new
mode is applied to the next sheet that is delivered to the IDM.
182 Xerox ® Versant ® 4100 Press
User Documentation
Working With