Xerox Phaser 3010, Service Manual

Page: 47 / 430

Phaser 3010/3040/WorkCentre 3045 Service Xerox Internal Use Only 1-25
General Information
First Print Output Time
First Print Output Time (FPOT) is defined as a time from when the engine receives
a Start signal in Ready state, until a single page is delivered to the output tray.
The following conditions are applied:
• The Controller does not keep the print engine waiting
• The printer is at Ready mode
• Paper is A size Short Edge Feed (SEF)
• Process control time is not included
First Copy Output Time
First Copy Output Time (FCOT) is the time required for the printer to deliver the
first sheet of paper after the user presses Start. The following conditions are
applied:
• The Controller does not keep the print engine waiting
• The printer is at Ready mode
• Paper is A size Short Edge Feed (SEF)
• The original is on the document glass or in the ADF
• Process control time is not included
IIT The Scanner and ADF are in standby,
ready to run.
Control Panel
Operation LCD - Backlight: On
LED: If printer is online, Ready LED is On.
Power Saver
Mode (Deep
Sleep) The printer enters Power Saver mode
when it has not received print data for the
specified time.
Recording The system is at Pause.
Fusing The system is Off.
IIT The Scanner and ADF are off.
Control Panel
Operation LCD: Off, LCD Backlight: Off
LED: Wake Up LED is On.
NOTE
When the printer receives a print or Fax job or the Wake Up/Power Saver button is pressed,
the printer exits the Power Saver mode and enters the Ready mode.
Mode Tray FPOT (sec.)
Mono Main 12.0 sec. or less
Bypass 12.0 sec. or less
Mode FCOT (sec.)
Mono 23.0 sec. or less
Mode Condition Description