Xerox Phaser 3010, Service Manual

Page: 213 / 430

Phaser 3010/3040/WorkCentre 3045 Service Xerox Internal Use Only 4-3
Service Parts Disassembly
Preparation
Before you begin any procedure:
Warning
Unplug the power cord from the wall outlet.
Warning
Allow the Fuser to cool before using the procedure.
Caution
Many parts are secured by plastic tabs. Do not over flex or force these parts.
Do not over torque screws threaded into plastic.
Note
Names of parts that appear in the removal procedures may not match the
names that appear in the Parts List. For example, a part called Paper Tray in a
removal procedure may appear on the Parts List as Cassette, Assy. While using
removal procedure, ignore any prerequisite procedures for parts already
removed.
1. Wear an Electrostatic Discharge wrist strap.
2. Turn Off power and disconnect the power cord from the wall outlet.
3. Disconnect all cables from the printer.
4. Remove the Toner Cartridges (page 4-5).
Notations in the Disassembly Text
• The notation “(item X)” points to a numbered callout in the illustration
corresponding to the disassembly procedure being performed.
• The notation “PL X.X.X ” indicates the component is listed in the Parts List.
• Arrows in an illustration show direction of movement when removing or
replacing a component.
• The notation “(tap, plastic, 10 mm)” or “(metal, 6 mm)” refer to the type of
screw being removed.
Replacement Note
Provides information specific to the replacement of parts or assemblies.