Xerox DocuColor 2240, Service Manual

Page: 280 / 1489

09/03
2-247
DC 3535/2240/1632, WC M24
12-120
Status Indicator RAPs Initial issue
12-120 Compiler Entrance Sensor On
The Compiler Entrance Sensor did not detect paper.
Initial Actions
• Check condition and specification of the paper supply.
• Check for obstructions in the paper feed path.
• Clean the H Transport Belt and check for wear.
• Check the Guides on the H Transport Cover for damage, wear or faulty installation
Procedure
Enter dC330 [012-101] and press Start . Open the H Transport Cover and actuate the Complier
Entrance Sensor ( PL 17.12 ) ( Figure 1 ) by manually feeding a sheet of paper through the Fin-
isher. The display changes.
Y N
Press Stop . Check the circuit of the Compiler Entrance Sensor ( Figure 2 ). Refer to the
OF 99-2 RAP for troubleshooting procedure.
Press Stop .
• Ensure that the connectors shown in the circuit diagram ( Figure 2 ) are securely con-
nected and that the wires are not damaged.
• Check the Finisher Drive Motor and its associated gears and belts ( PL 17.4 , PL 17.7 ) for
damage, contamination or misalignment.
• Decurler Roll/Pinch Roll for a drive failure ( PL 17.7 ).
• Replace the Compiler Entrance Sensor ( PL 17.12 ).
• If the problem persists, replace the Finisher PWB ( PL 17.13 ) ( Figure 3 ).
Figure 1 Component Location
Figure 2 12-120 RAP Circuit Diagram - Compiler Entrance Sensor
Figure 3 Finisher PWB
Compiler
Entrance
Sensor
Home
Sensor
Decurler Clutch