Xerox DocuColor 2240, Service Manual

Page: 164 / 1489

09/03
2-131
DC 3535/2240/1632, WC M24
7-122
Status Indicator RAPs Initial issue
7-122 Tray 4 Opened (TTM)
The Tray 4 Feed Out Sensor detected paper when Tray 4 is pulled out and pushed in during a
print.
Initial Actions
• Check condition and specification of paper in Tray 4.
• Check the paper path for obstructions and clean the Tray 4 Feed Out Sensor.
• Check the Tray 4 mechanical operation.
• Check that Tray 4 is properly closed.
Procedure
Enter dC330 [008-103] and press Start . Block and unblock the Tray 4 Feed Out Sensor ( PL
16.5 ) by sliding Tray 4 in and out of the machine. The display changes.
Y N
Press Stop . Check the circuit of the Tray 4 Feed Out Sensor ( Figure 1 ). Refer to the OF
99-1 RAP for troubleshooting procedure.
Press Stop .
• Ensure that the connectors shown in the circuit diagram ( Figure 1 ) are securely con-
nected and that the wires are not damaged.
• Check the machine Shutdown History Report. If there is a history of this failure, replace
the Tray 4 Feed Out Sensor (
PL 16.5 ).
• If the problem continues, replace the Tray Module PWB ( PL 16.15 ).
Figure 1 7-122 RAP Circuit Diagram - Tray 4 Feedout Sensor (TTM)