Xerox ColorQube 9303, User Manual

Page: 244 / 352

Tray 5
ColorQube™ 9301/9302/9303
Paper and Media 244
Tray 5
Tray 5 is an optional high capacity paper source. When installed, Tray 5 takes priority as the primary
paper feeder. This tray is a dedicated tray and as standard feeds A4 or 8.5x11” Long Edge Feed (LEF)
media. Additional kits can be purchased and enable the tray to take either A4, 8.5x11” or 8.5 x 14”
Short Edge Feed (SEF), or A3 or 11x17” SEF. The following media can be loaded in Tray 5:
• Up to 4000 sheets of 75 gsm or 20 lb paper (A4 or 8.5x11” LEF), up to 2000 sheets of 75 gsm or
20 lb paper (additional kits).
• Weights from 60 to 216 gsm (16 to 56 lb).
• Media types:
• Bond, standard or recycled paper
• Card
• Pre-printed media
• Hole punched paper
Tray 5 must not be used to feed labels, transparencies, envelopes, tabs or carbonless paper. Tray 4
(Bypass) can be used for these media types.
Loading Tray 5
The media size and type requested must be loaded in the tray and the settings cannot be adjusted by
the user.
Note Your device does not warn you if the wrong sized media is loaded.
CAUTION: A problem may occur if a tray is opened while it is being used to feed media.
1. Press the button to open the door.
Opening the tray automatically lowers an elevator in the base of the tray. Wait for the paper tray
to lower.
2. The media required is displayed on
the screen. Ensure the correct media is
loaded.
3. Place the media in the tray. Media
must be positioned against the right
side of the tray.
• Load pre-printed paper face
down and with the top towards
the front of the device.
• Load hole punched paper with
the holes on the left edge.
Paper must not be loaded above the maximum fill line.
4. Close the door.
When the door is closed the elevator rises to feed the media.