
Maintenance
222
Xerox
®
AltaLink
®
B80XX Series Multifunction Printer
User Guide
Transfer Roller
This section includes:
•
General Precautions ...................................................................................................................................................... 222
•
Replacing the Transfer Roller .................................................................................................................................... 222
•
Resetting Supply Life Counters ................................................................................................................................. 224
General Precautions
WARNING:
When replacing consumables do NOT remove the covers or guards that are
fastened with screws. You cannot maintain or service any of the parts that are behind these
covers and guards. Do NOT attempt any maintenance procedure that is NOT specifically
described in the documentation supplied with your device.
Replacing the Transfer Roller
A Low Supply Warning message may appear on the control panel when the transfer roller is nearing end
of life.
If ghosting appears in printed output, check the percentage of remaining life for the transfer roller.
Replace the transfer roller when the percentage of remaining life is less than 20 percent. For details, refer
to
Supply Status
on page 201.
Note:
Each transfer roller includes installation instructions.
To replace the transfer roller:
1.
Power off the printer, then disconnect the power cord from the printer.
2.
Remove any paper from Tray 5.
3.
Open the left side door of the printer.