
Maintenance
Xerox
®
AltaLink
®
B80XX Series Multifunction Printer 219
User Guide
Fuser Module
This section includes:
•
General Precautions ...................................................................................................................................................... 219
•
Replacing the Fuser Module ...................................................................................................................................... 219
General Precautions
WARNING:
When replacing consumables do NOT remove the covers or guards that are
fastened with screws. You cannot maintain or service any of the parts that are behind these
covers and guards. Do NOT attempt any maintenance procedure that is NOT specifically
described in the documentation supplied with your device.
Replacing the Fuser Module
A Low Supply Warning message may appear on the control panel when the fuser module is nearing end
of life.
If print output shows smears of toner, check the percentage of remaining life for the fuser module.
Replace the fuser module when the percentage of remaining life is less than 20 percent. For details, refer
to
Supply Status
on page 201.
Note:
Each fuser module includes installation instructions.
To replace the fuser:
1.
Power off the printer, then disconnect the power cord from the printer.
2.
Remove any paper from Tray 5. Open the left side door of the printer, then wait for 5 minutes.