wsm Kubota L4100, Workshop Manual

Page: 208 / 346

REAR AXLE L4100, WSM
4-S4
(EU)
Wiring Harness
• Disconnect rear combination lamp connector (R.H.) (1) and
L.H., PTO switch connectors (2), PTO shift cable (3), and then
clear wiring harness from fender.
9Y1210278BRS0016US0
Rear Wheel and Fender
1. Place a jack under the transmission case.
2. Loosen and remove the rear wheel mounting screws and nuts.
3. Remove the rear wheels (2).
4. Remove the fenders (1).
5. Follow the same procedure as above for the other side.
(When reassembling)
9Y1210278RAS0005US0
Rear Axle Case
1. Place the support stand under the rear axle case.
2. Loosen and remove the rear axle case mounting screws and
nuts.
3. Support the rear axle case with nylon lift strap and hoist.
4. Separate the rear axle case from brake case.
(When reassembling)
• Apply liquid gasket (Three Bond 1206C or equivalent) to joint
face of the rear axle case and brake case, after eliminate the
water, oil and stuck liquid gasket.
9Y1210278TRS0015US0
(1) Rear Combination Lamp Connector
(R.H.)
(2) PTO Switch Connector
(3) PTO Shift Cable
Tightening torque
Rear wheel mounting
screw and nut
197 to 225 N·m
20.0 to 23.0 kgf·m
145 to 166 lbf·ft
(1) Fender (2) Rear Wheel
Tightening torque
Rear axle case
mounting
screw and nut
M10
screw
48 to 55 N·m
4.9 to 5.7 kgf·m
36 to 41 lbf·ft
M10 nut
61 to 70 N·m
6.2 to 7.2 kgf·m
45 to 52 lbf·ft
M12
screw
78 to 90 N·m
7.9 to 9.2 kgf·m
58 to 66 lbf·ft
Stud bolt
25 to 31 N·m
2.5 to 3.2 kgf·m
18 to 23 lbf·ft
KiSC issued 08, 2012 A