wsm Kubota L4100, Workshop Manual

Page: 187 / 346

TRANSMISSION L4100, WSM
3-S24
(EU)
Gear Shaft Assemblies
1. Remove shift fork assembly (1), (2) together with counter gear
shaft assembly (3).
2. Remove main gear shaft assembly (4), I-PTO counter gear
shaft assembly (5), I-PTO gear shaft assembly (6), and then
PTO gear shaft (7).
NOTE
• To easily remove the gear shaft assembly, tap lightly a tool,
like the one shown in the photo, through small holes (8)
from front inside wall of clutch housing.
9Y1210278TRS0021US0
Rear Propeller Shaft
1. Pull out front axle drive shaft (1) from the rear.
(When reassembling)
• Install bearing (6), spacer (5), oil seal (4) and internal snap ring
to clutch housing (8).
• Install sleeve (7) to the rear propeller shaft with dimension
shown on the figure, then install the rear propeller shaft from the
rear.
• Install sleeve (2) by using rear propeller shaft tool.
9Y1210278TRS0022US0
(1) Shift Fork Assembly (1 - 2)
(2) Shift Fork Assembly (3 - 4)
(3) Counter Gear Shaft Assembly
(4) Main Gear Shaft Assembly (5) I-PTO Counter Gear Shaft
Assembly
(6) I-PTO Gear Shaft Assembly
(7) PTO Gear Shaft
(8) Hole
(1) Rear Propeller Shaft
(2) Sleeve
(3) Internal Snap Ring
(4) Oil Seal
(5) Spacer
(6) Bearing (7) Sleeve
(8) Clutch Housing
A: To Front Propeller Shaft
L: 538 mm (21.2 in.)
KiSC issued 08, 2012 A