wsm Kubota L4100, Workshop Manual

Page: 185 / 346

TRANSMISSION L4100, WSM
3-S22
(EU)
[3] DISASSEMBLING AND ASSEMBLING
(1) Clutch Housing
Clutch Lever, Release Fork and Release Bearing
1. Remove the release fork mounting screws (2).
2. Draw out the clutch lever (3) to remove the release fork (1).
3. Remove the release bearing (4) together with release holder.
(When reassembling)
• Apply grease to the sliding surface of the clutch release hub.
• Apply grease to the clutch lever.
9Y1210278TRS0062US0
Shaft Case
1. Remove the shaft case mounting screws.
2. Remove the shaft case (1) by using two jack screws M6.
(When reassembling)
• Apply liquid gasket (Three Bond 1206C or equivalent) to joint
surface of the shaft case and clutch housing case after
eliminating the water, oil and stuck liquid gasket.
(When replacing oil seal in shaft case)
• Install the oil sea (3) as shown in the figure, noting its direction.
• Apply grease to the oil seal (3).
9Y1210278TRS0063US0
Tightening torque
Clutch release fork
mounting screw
24 to 27 N·m
2.4 to 2.8 kgf·m
18 to 20 lbf·ft
(1) Release Fork
(2) Release Fork Mounting Screw (3) Clutch Lever
(4) Release Bearing
Tightening torque
Clutch release fork setting
screw
24 to 27 N·m
2.4 to 2.8 kgf·m
18 to 20 lbf·ft
(1) Shaft Case
(2) Jack Screw M6 (3) Oil Seal
KiSC issued 08, 2012 A