wsm Kubota L4100, Workshop Manual

Page: 170 / 346

TRANSMISSION L4100, WSM
3-S7
(EU)
4. CHECKING, DISASSEMBLING AND SERVICING
[1] CHECKING AND ADJUSTING
(1) Range Gear Shift Lever
CAUTION
• Park the tractor on a firm and level ground and set the parking brake.
• Lower the loader and other implement to the ground.
• Stop the engine, and remove the key.
When shifting slowly the range gear shift lever from the position H (High) to the position N (Neutral), the gear
inside sometimes remains at the position H and does not move, although the range gear shift lever is at the position N .
It has been caused by a bad adjustment of the turnbuckle.
Please verify and adjust the turnbuckle as follows.
9Y1210278TRS0006US0
Checking Range Gear Shift Lever Neutral Position
1. Shift the range gear shift level to N (Neutral) position on the H
(High) speed side. Keeping the lever slightly being pushed
forward (to the left of the photo), measure the overlapping
length
"A" of the level and guide.
2. Judgement
[1] CORRECT
Length "A" is 1 to 5 mm (0.04 to 0.2 in.) when the guide and
lever are overlapping.
[2] INCORRECT
The overlapping length "A" is less than 1 mm (0.04 in.), or when
there is a clearance between the guide and lever. In this case,
carry out the following adjustment.
9Y1210278TRS0045US0
A: Overlapping length of the level
and guide.
P: The free play stroke of range
lever.
a: The forward position of range
lever in neutral position.
b: The backward position of range
lever in neutral position.
c: The end of the guide.
KiSC issued 08, 2012 A