wsm Kubota L4100, Workshop Manual

Page: 221 / 346

BRAKES L4100, WSM
5-S7
(EU)
Brake Case
1. Remove the brake case mounting screws and nuts.
2. Separate the brake case, tapping the brake case lever lightly.
(When reassembling)
• Apply grease to the brake ball seats. (Do not grease
excessively.)
• Apply liquid gasket (Three Bond 1206C or equivalent) to joint
face of the brake case and transmission case, around hole "A"
after eliminate the water, oil and stuck liquid gasket.
• Before installing the brake case to the transmission case, install
the cam plate to the transmission case.
9Y1210278BRS0014US0
[3] DISASSEMBLING AND ASSEMBLING
Brake Case, Brake Assembly
1. Remove the brake case mounting screw (1).
2. Remove the brake case (2).
3. Remove the brake shaft (3) with brake discs (6) and plates (7).
4. Remove the brake cam plate (5) and steel balls.
(When reassembling)
• Place the brake discs (6) so that the hole "A" of brake discs
should be overlapped 50 % or more.
• Apply liquid gasket (Three Bond 1206C or equivalent) to joint
face of the brake case and differential gear case, after eliminate
the water, oil and stuck liquid gasket.
9Y1210278BRS0015US0
Tightening torque
Brake case mounting stud
bolt
39 to 45 N·m
3.9 to 4.6 kgf·m
29 to 33 lbf·ft
Brake case mounting screw
and nut
78 to 90 N·m
7.9 to 9.2 kgf·m
58 to 66 lbf·ft
Brake case lever mounting
screw
63 to 72 N·m
6.4 to 7.4 kgf·m
47 to 53 lbf·ft
Tightening torque
Rear wheel mounting
screw and nut
197 to 225 N·m
20.0 to 23.0 kgf·m
145 to 166 lbf·ft
(1) Brake Case Mounting Screw
(2) Brake Case
(3) Brake Shaft
(4) Steel Ball (5) Brake Cam Plate
(6) Brake Disc
(7) Plate
KiSC issued 08, 2012 A