wsm Kubota L4100, Workshop Manual

Page: 30 / 346

GENERAL L4100, WSM
G-15
(EU)
7. CHECK AND MAINTENANCE
CAUTION
• Be sure to check and service the machine on a flat place with engine shut off, the parking brake on and
chock the wheels.
9Y1210278GEG0010US0
[1] DAILY CHECK
To prevent trouble from occurring, it is important to know the condition of the machine. Check the following items
before starting.
9Y1210278GEG0011US0
Checking
• Check areas where previous trouble was experienced.
• Walk around the machine.
1. Check the tire pressure, and check for wear and damage.
2. Check for oil and water leak.
3. Check the engine oil level.
4. Check the transmission fluid level.
5. Check the coolant level.
6. Check the condition of seat belt and ROPS attaching hardware.
7. Check the clean the radiator screen and grill.
8. Check the nuts of tires are tight.
9. Care of damage, warning and caution labels.
10. Clean around the exhaust manifold and the muffler of the engine.
11. Clean the evacuator valve.
12. Check and clean of electrical wiring and battery cables.
• While sitting in the operator's seat,
1. Check the brake pedals and clutch pedal.
2. Check the parking brake.
3. Check the steering wheel.
• Turning the key switch
1. Check the performance of the Easy Checker™ lights.
2. Check the lights, turn signal lights, hazard lights and other light equipment. Clean if necessary.
3. Check the performance of the meters and gauges.
• Starting the engine,
1. Check to see that the lights on the Easy Checker™ go off.
2. Check the color of the exhaust gas.
3. Check the brakes for proper operation.
9Y1210278GEG0012US0
[2] CHECK POINTS OF INITIAL 50 HOURS
Adjusting Clutch Pedal Free Travel
1. Slightly depress the clutch pedal (4) and measure free travel on
top of clutch pedal.
2. If the measurement is not within the factory specifications,
loosen the lock nut (2), remove the cotter pin (3) and the clevis
pin, then adjust the length of rod (1) within acceptable limits.
3. Retighten the lock nut, reinstall the clevis pin, the cotter pin and
split the cotter pin.
9Y1210278CLS0006US0
Clutch pedal free travel
on top of clutch pedal
Factory specification
20 to 30 mm
0.8 to 1.2 in.
(1) Clutch Pedal Rod
(2) Lock Nut
(3) Cotter Pin (4) Clutch Pedal
L: Clutch Pedal Free Travel
KiSC issued 08, 2012 A