wsm Kubota L4100, Workshop Manual

Page: 43 / 346

GENERAL L4100, WSM
G-28
(EU)
Changing Transmission Fluid
1. Place an oil pan underneath the transmission case.
2. Remove the drain plugs (1), (2).
3. Drain the transmission fluid.
4. Reinstall the drain plugs (1), (2).
(When refilling)
• Fill up new oil from the oil filling port (3) up to the upper line of
the oil level gauge (4).
• After running the engine for few minutes, stop it and check the
oil level again, add oil to prescribed level, if necessary.
IMPORTANT
• Use only multi-grade transmission fluid. Use of other fluids
may damage the transmission or hydraulic system.
Refer to "LUBRICANTS, FUEL AND COOLANT". (See page
G-9.)
• Never work the tractor immediately after changing the
transmission fluid. Keeping the engine at medium speed
for a few minutes to prevent damage to the transmission.
• Do not mix different brands oil together.
9Y1210278GEG0072US0
Changing Front Axle Case Oil
1. Place the oil pans underneath the front axle case.
2. Remove the drain plug (3) both sides and filling port plug (2) to
drain the oil.
3. After draining, reinstall the drain plugs (3) and filling port plug
(2).
(When reassembling)
• Remove the filling port plug (2) and right and left check plugs
(1).
• Fill with the new oil.
• After filling, reinstall the port plug (2).
IMPORTANT
• Use KUBOTA SUPER UDT fluid or SAE 80, 90 gear oil.
Refer to "LUBRICANTS, FUEL AND COOLANT". (See page
G-9.)
9Y1210278GEG0073US0
Transmission fluid Capacity
40.0 L
10.6 U.S.gals
8.80 Imp.gals
(1) Drain Plug
(2) Drain Plug
(3) Oil Filling Port
(4) Oil Level Gauge A: Oil level is acceptable within this
range.
Front axle case oil Capacity
6.5 L
6.9 U.S.qts
5.7 Imp.qts
(1) Check Plug
(2) Filling Port Plug (3) Drain Plug
KiSC issued 08, 2012 A