wsm Kubota L4100, Workshop Manual

Page: 186 / 346

TRANSMISSION L4100, WSM
3-S23
(EU)
24T Gear Shaft and 27T Gear
1. Remove the 24T gear shaft (1).
2. Remove the external snap ring (2) and 27T gear (3).
9Y1210278TRS0019US0
Clutch Housing Bearing Holder
1. Remove clutch housing bearing holder (2) mounting screws.
2. Remove three interlock balls (4) after removing stopper screw
(1).
3. Pull out clutch housing bearing holder (2) by using two jack
screws M8 (3).
NOTE
• Take care not to fly out interlock balls (4) and springs (6)
when pull out bearing holder (2).
(When reassembling)
• Install three interlock balls (4) with a small amount of grease to
clutch housing bearing holder (2) after setting the shift forks and
shift rods to neutral position.
9Y1210278TRS0064US0
(1) 24T Gear Shaft
(2) External Snap Ring (3) 27T Gear
Tightening torque
Clutch housing bearing
holder mounting screws
48 to 55 N·m
4.9 to 5.7 kgf·m
36 to 41 lbf·ft
Interlock ball stopper screw
35 to 44 N·m
3.5 to 4.5 kgf·m
26 to 32 lbf·ft
(1) Interlock Ball Stopper Screw
(2) Clutch Housing Bearing Holder
(3) Jack Screw M8 (4) Interlock Ball
(5) Shift Lock Ball
(6) Spring
KiSC issued 08, 2012 A