wsm Kubota L4100, Workshop Manual

Page: 337 / 346

ELECTRICAL SYSTEM L4100, WSM
9-S20
(EU)
Flasher Unit
1. Disconnect the connector from the flasher unit.
2. Turn the main switch at
ON position.
3. Measure the voltage between the 12, 13 terminal and chassis.
4. If the voltage differ from the battery voltage, the wiring harness
is faulty
(Reference)
Q
Flasher Unit Action Test
1. Set the hazard switch to the ON position, and make sure the
hazard light gives 60 to 120 flashers for a minute.
2. Set the main switch to the ON position and move the turn signal
switch to the left. Make sure the left-hand light gives flashes.
Then move the turn signal switch to the right and make sure the
right-hand light gives flashes. Make sure the same actions as
above result.
3. If both the hazard switch and the turn signal switch and the turn
signal switch function but the above actions do not take place,
replace the flasher unit with new one.
9Y1210278ELS0021US0
Voltage
12 terminal – Chassis Approx. battery voltage
13 terminal – Chassis Approx. battery voltage
1 0.85Y Lighting switch
2 0.85Y/R Position light
3 0.5W/B Position light switch
4 0.85R/Y Main switch (AC)
5 0.85R/W Turn signal light (R)
6 0.5G/R Turn signal light switch (R)
7 0.5B/W Ground
8 0.85G/W Turn signal light (L)
9 0.5W/G Turn signal light switch (L)
10 0.5G/B Hazard indicator lamp
11 0.5W/L Hazard switch
12 1.25R/B Battery voltage
13 0.85R/L Battery voltage (lighting)
(1) Flasher Unit
KiSC issued 08, 2012 A