wsm Kubota L4100, Workshop Manual

Page: 31 / 346

GENERAL L4100, WSM
G-16
(EU)
Changing Engine Oil
CAUTION
• Before changing oil, be sure to stop the engine.
1. Start and warm up the engine for approx. 5 minutes.
2. Place an oil pan underneath the engine.
3. To drain the used oil, remove the drain plug (1) at the bottom of
the engine and drain the oil completely.
4. Screw in the drain plug (1).
5. Fill new oil up to upper hole on the dipstick (3).
IMPORTANT
• When using an oil of different manufacture or viscosity
from the previous one, remove all of the old oil.
• Never mix two different types of oil.
• Use the proper SAE Engine Oil according to ambient
temperatures.
• Refer to "LUBRICANTS, FUEL AND COOLANT". (See page
G-9).
9Y1210278GEG0013US0
Replacing Engine Oil Filter Cartridge
CAUTION
• Be sure to stop the engine before changing oil filter
cartridge (1).
• Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. Remove the engine oil filter cartridge (1).
2. Put a film of clean engine oil on rubber seal of new filter.
3. Tighten the filter quickly until it contacts the mounting surface.
Tighten filter by hand an additional 1/2 turn only.
4. After the new filter has been replaced, the engine oil normally
decreases a little. Make sure that the engine oil does not leak
through the seal and be sure to check the oil level on the
dipstick. Then, replenish the engine oil up to the prescribed
level.
IMPORTANT
• To prevent serious damage to the engine, use only a
KUBOTA genuine filter.
9Y1210278GEG0014US0
Engine oil
(with filter)
Capacity
7.6 L
8.0 U.S.qts
6.7 Imp.qts
(1) Drain Plug
(2) Oil Inlet Plug
(3) Dipstick (A) Oil lever is acceptable within this
range.
(1) Engine Oil Filter Cartridge
KiSC issued 08, 2012 A