wsm Kubota L4100, Workshop Manual

Page: 184 / 346

TRANSMISSION L4100, WSM
3-S21
(EU)
Rear Axle Case
1. Place the support stand under the rear axle case.
2. Loosen and remove the rear axle case mounting screws and
nuts.
3. Support the rear axle case with nylon lift strap and hoist.
4. Separate the rear axle case from brake case.
(When reassembling)
• Apply liquid gasket (Three Bond 1206C or equivalent) to joint
face of the rear axle case and brake case, after eliminate the
water, oil and stuck liquid gasket.
9Y1210278TRS0015US0
Brake Case
1. Remove the brake case mounting screws and nuts.
2. Separate the brake case, tapping the brake case lever lightly.
(When reassembling)
• Apply grease to the brake ball seats. (Do not grease
excessively.)
• Apply liquid gasket (Three Bond 1206C or equivalent) to joint
face of the brake case and transmission case, around hole "A"
after eliminate the water, oil and stuck liquid gasket.
• Before installing the brake case to the transmission case, install
the cam plate to the transmission case.
9Y1210278TRS0048US0
Tightening torque
Rear axle case
mounting
screw and nut
M10
screw
48 to 55 N·m
4.9 to 5.7 kgf·m
36 to 41 lbf·ft
M10 nut
61 to 70 N·m
6.2 to 7.2 kgf·m
45 to 52 lbf·ft
M12
screw
78 to 90 N·m
7.9 to 9.2 kgf·m
58 to 66 lbf·ft
Stud bolt
25 to 31 N·m
2.5 to 3.2 kgf·m
18 to 23 lbf·ft
Tightening torque
Brake case mounting stud
bolt
39 to 45 N·m
3.9 to 4.6 kgf·m
29 to 33 lbf·ft
Brake case mounting screw
and nut
78 to 90 N·m
7.9 to 9.2 kgf·m
58 to 66 lbf·ft
Brake case lever mounting
screw
63 to 72 N·m
6.4 to 7.4 kgf·m
47 to 53 lbf·ft
KiSC issued 08, 2012 A