Wexxar WF30T, Operation And Service Manual

Page: 73 / 190

WF30T Case Former Case Size Adjustments
7-60
7.3 Formed Case Height (Dimension ‘E’)
Figure 7-7: Dimension ‘E’
Measure the height of the formed case with the bottom minor flaps folded. The machine must be
adjusted so that the vertical distance between the top of the minor flap folders (
DOWN
position)
and the bottom of the pinblocks on the jawplates (forming head fully
DOWN
) is
"
8
1
(3 mm)
greater
than Dimension 'E'.
Proceed as follows:
1. Ensure that the case forming head is resting on
the head-up latch. Do this easily by pressing the
‘EMERGENCY STOP’
button while the machine
is stopped normally.
2. Loosen the two yellow clamp handles which
clamp the forming head assembly to the two
8
5
”
diameter (16 mm) driverods.
3. Using the yellow knob handle provided, move
the drive rods to achieve the required Dimension
‘E’ setting.
4. Retighten the clamps securely.
Figure 7-9: Dimension ‘E’ Adjustments
Figure 7-8: Head-up Latch
Dimension ‘E’
Adjustment scale
Yellow knob:
Dimension ‘E’
Adjustment
handle
Dimension ‘E’ Adjustment
clamp lock handles
Head-up latch