Removing the accumulator head and replacing its seals
September 26, 2013, 715004208 Rev. A
127
12. Using the T27 TORX driver, loosen the two head bolts 1/2-turn.
Tip:
The bolts are accessible from the front of the pressure transducer.
13. Using the T27 TORX driver, loosen and remove the 2 support plate
bolts, and then gently pull the head and support plate off the actuator
housing, making sure not to tilt the head during the extraction.
Caution:
To avoid damaging the plunger, support the pump head
from below as you remove it.
Head bolt (2)
Support plate bolt (2)