&
+$37(5
0
$,17(1$1&(
<
2.(
$
66(0%/<
105
C O N F I D E N T I A L
0 2 . 9 6 3 8 . 0 0 1 0
2 3 - A u g - 9 9
Step 3. At tilt-side yoke leg, disconnect head assembly lamp wires and
ground cable (
).
a. Using diagonal cutters, remove cable tie securing tilt cable to
tilt mechanism.
b. At terminal strip, using #1 slotted screwdriver, disconnect
lamp wires extending from head.
c. Using diagonal cutters, remove two cable ties securing lamp
and ground wires to yoke leg.
d. At ground stud, using 5/16 inch nutdriver, remove 6-32 Keps
nut securing ring terminals of ground wires. Remove ring
terminal of head assembly ground cable from stud.
Figure 3-24: Tilt Side Yoke Leg
Step 4. Remove pulley.
a. At tilt mechanism, using 5/32 inch Allen wrench, loosen belt.
b. Using screwdriver, loosen three 6-32x5/16" PPZ screws and
#6 flat washers that secure tilt mechanism to yoke leg and
push tilt mechanism as close to pulley as possible without
removing.
c. At pulley, using 5/16 inch nutdriver, gradually loosen four
acorn nuts in cross pattern (to prevent pulley from cracking).
LMPWRDSC
Ground Stud
Pulley
Tilt Mechanism
Adjustment Screw
Acorn Nut
Head
Lamp Wires
(From Head)
Terminal Strip
Disconnect lamp wires.
Ground Cable
Lamp Wires
(From Head)
Remove cable ties.
