&
+$37(5
0
$,17(1$1&(
+
($'
$
66(0%/<
85
C O N F I D E N T I A L
0 2 . 9 6 3 8 . 0 0 1 0
2 3 - A u g - 9 9
CAUTION: Wear cotton gloves or finger cots when handling beam size
iris leaves, gobos, or filters.
Step 4. Remove wheel assembly by one of the following methods:
a. If Ultra Mini-Bars are available:
1) Put on white cotton gloves.
2) Remove filter or gobo in wheel position 6 (opposite open
space (position 0).
3) Using two mini-bars, from opposite sides, pry wheel
loose.
b. If wheel assembly wheel has two thru holes at center of
wheel, insert IC extraction tool legs thru holes and pull wheel
assembly off of motor shaft.
c. If wheel does not have holes for IC extractor tool, do the fol-
lowing:
1) Put on white cotton gloves.
2) Remove filter or gobo in wheel position 6 (opposite open
space (position 0).
3) Grasp wheel with fingers in wheel position 0 and 6
openings and carefully remove wheel.
Step 5. Remove and replace filters or gobos as required.
Step 6. From back of motor, press on shaft while pushing on wheel
assembly to allow retaining clip to latch (
).
Figure 3-11: Gobo/Filter Wheel Assembly Replacement
Slide retaining clip into
notch in motor shaft.
Press up on shaft with screwdriver
to slide retaining clip into motor
shaft notch.
Press here