TV One C2-4000 Series, User Manual

Page: 36 / 108

C2-4000 Series RGB Scaler Operation Manual
35
In the screen example shown above, the “SW 166” portion of the display
refers to the software revision number. The “PT: 10 and BT: 6” portions of
the sample display refer to the Hardware version number. You cannot
upgrade the hardware however it’s useful information in the event you contact
our Technical Support group.
10.3 Program Source
The Program Source LCD display shows the signal source that has been
selected as the main input to the Scaler engine. This is the only input that
supports special processing such as Zoom or Shrink. The top line of the
display shows the characteristics of the signal. In this case, the signal is made
up of 1024 pixels in the horizontal dimension and 768 pixels in the Vertical
dimension.
These pixels, or picture elements, are repeating at a rate of 60 times per
second. (The “Hz” in “60 Hz” is an abbreviation for “Hertz”, the name of a
physicist who studied electrical waves. Hz refers to how many cycles of a
wave occur each second. In this case, the picture is repeating at a cyclic rate
of 60 times per second hence the 60 Hz designation in the display).
The bottom line indicates the input chosen for the Scaler engine. This display
tracks the input button selected but can also be changed via the Menu Select
knob. To change the input by use of the knob, press the knob once while on
the above screen. This will cause the brackets surrounding the input selection
to begin flashing. When the flashing begins, rotate the Menu Select knob until
the desired input appears between the brackets. Pressing the Menu Select
knob again will stop the brackets from flashing and will also cause your
selection to be loaded into temporary memory where it will remain until
manually changed or until the unit’s AC power source is disconnected.
10.4 Preview Source
The Preview Source functionality is provided so you can see the content or
quality of an image before you place it on the program channel.
In the Factory Default mode, the Program and Preview outputs track meaning
both are switched at the same time. In the Adjust Buttons Submenu, the two
functions can be separated allowing the Preview functionality to operate
independently of the Program function or act as a fixed pass through. The
procedure for separating the two functions will be discussed when we reach
the Adjust Buttons submenu.
www.tvone.com
SW 166, PT: 10 BT: 6
1024 x 768 60Hz
Program Source [RGB1]