TV One C2-4000 Series, User Manual

Page: 24 / 108

C2-4000 Series RGB Scaler Operation Manual
23
Rotate the Menu Select knob to the right and press the knob again. This
notifies the Scaler that you are about to change the input assignment to input
number “3”. The brackets will disappear from around the input number and
will appear around the section of the display that says “Input=RGB3”. The
LCD screen will look like this:
Press the knob again and the brackets will begin to flash indicating that the
Scaler is ready to accept the new input assignment. Rotate the Menu Select
knob to the left until the number “1” appears and then select it by pressing the
knob again. The flashing will cease and the LCD display will now look like this:
Rotate the Menu Select knob to the right until the below depicted display
appears.
Pressing the Knob causes an exit of the Adjust Buttons routine. You can now
move the Menu Select knob Counter-clockwise until it’s back at the Banner
Screen.
(NOTE: Selections made in this Quick Start section only store into
temporary memory. A way to make your choices permanent will be explained
later in this manual)
7.2 Quick Start: Picture-In-Picture
Picture In Picture (PIP) has four components: Background Source,
Foreground Source, Amount of Shrinkage of the inserted image (measured as
a percentage with 100% being full screen) and, finally, the Position of the
Inserted image.
For this tutorial, we’ll use two image sources: RGB1 (the background) and
RGB2 (the image to be shrunk). A second PC will do nicely for the number 2
RGB source. Although both sources in this example are RGB images, your
sources can be whatever you want. Just remember to substitute your own
background image selection for RGB1 and your PIP image selection (the
image to be shrunk) for RGB2. Before we begin, perform the Factory Reset
procedure explained above.
Adjust Buttons
Button 3 = [Input=RGB3]
Adjust Buttons
Button 3 = [Input=RGB1]
Adjust Buttons
Exit