TV One C2-4000 Series, User Manual

Page: 30 / 108

C2-4000 Series RGB Scaler Operation Manual
29
Press the knob once to notify the Scaler that you want access to these menus
and then rotate the knob to the right until the following screen appears:
Press the knob and, when the brackets surrounding the “0” begin to flash,
rotate the knob to the right until the background image disappears. When that
happens, rotate the knob back to the left until the background image
reappears and then continue for another four detents. Press the knob once,
which loads the minimum “Y” value into memory. Rotate the knob to the right
and press it once observing the flashing brackets around the right hand
number. Rotate the knob to the left until the background image disappears
and then rotate it back to the right until the keyed image has no bleeding,
tearing or other defects. Press the knob once to load the maximum “Y” value
into memory. You will now see a properly keyed image on the monitor and
the LCD display will show values somewhere between 0 and 255 in the
minimum and maximum readout display areas.
After you have made your level selections, rotate the Menu Select knob to the
right until the following screen appears:
Press the knob once and then rotate the knob to the left until you are back on
the Banner screen.
7.4 Quick Start: Zooming the Image
You’ll be happy to know that zooming an image is very simple however we
still need to perform the Factory Reset procedure to once again start the
tutorial with a clean slate. After you have done so, select either of your input
sources by pressing the appropriate input buttons. Starting from the Banner
screen, begin rotating the Menu Select knob to the right. The LCD screen we
want will be the Adjust Scaler parameters display as shown:
Pressing the knob once reveals the following screen:
Adjust Lock/Overlay
Y key min/max [ 0] 32
Adjust Lock/Overlay
Y key min/max 14 [ 32]
Adjust Lock/Overlay
Exit
Sub menu . . .
Adjust Scaler parameters
Adjust Scaler Parameters
Zoom Level % [ 100%]