C2-4000 Series RGB Scaler Operation Manual
30
Pressing the knob again causes the brackets to begin flashing. Rotate the
Menu Select knob to the right to zoom the image up to 1000%. Press the
knob once to load the value into memory.
Enlarging the center of the image is nice but what if you are interested in
something other than the middle of a picture? Fortunately, there are
adjustments available that allow you to pan the image both horizontally and
vertically.
After you have selected and saved the zoom percentage, rotate the Menu
Select knob to the right until you see the following screen:
Pressing the knob will cause the brackets surrounding the left number to
begin flashing. Rotating the knob will cause a horizontal movement of the
image with a Clockwise rotation causing the image to move to the left and a
Counter-clockwise rotation causing a movement to the right. When you have
reached the desired position horizontally, press the knob to load the result into
memory. Move the brackets over to the right hand number by rotating the
knob one detent to the right and pressing the knob. The brackets will begin to
flash again and you can make the vertical adjustment so as to place the
image at exactly the desired position. Press the knob to load that value into
memory and then rotate the Menu Select knob to the right until the exit screen
is reached:
Press the knob to exit the adjustment area and then rotate the knob Counter-
clockwise until you are back at the Banner screen.
These four features represent the areas of highest user interest. An
understanding of these basics is a prerequisite to understanding the C2-4100
RGB Scaler. You should use this Quick Start tutorial as a get acquainted
exercise because menu navigation (along with the RS-232/Ethernet interface)
is the basis for unlocking the power of the Scaler. Remember that we haven’t
touched upon many other features. All of that will come later but for now,
become proficient with the four features described above before you move
further into the manual.
8.0
I/O Signal Flow
The Scaler has three RGB inputs (two with HD-15 inputs and one with 5 BNC
inputs). Provision is made for RGB Program outputs: one HD-15 and one set
of 5 BNC connectors. An HD-15 Preview output is also provided.
Adjust Scaler Parameters
H/V zoom pan % [ 50] 50
Adjust Scaler Parameters
Exit
Summary of Contents for C2-4000 Series
