C2-4000 Series RGB Scaler Operation Manual
20
The wire colored BROWN must be connected to the terminal marked with the
letter L or colored RED. (Make sure that neither of these wires is connected
to the earth terminal of the three-pin plug).
The wire colored GREEN & YELLOW must be connected to the terminal
marked with the letter E or colored GREEN or GREEN & YELLOW or marked
with a ground symbol.
NOTE: POWER IS NEVER TOTALLY REMOVED FROM THE UNIT WHEN
IT’S PLUGGED INTO AN ACTIVE AC OUTLET. PRESSING THE BUTTON
AT THE EXTREME RIGHT ON THE FRONT PANEL ONLY PLACES THE
UNIT IN A POWERED DOWN MODE. THIS BUTTON IS A STANDBY
SWITCH, NOT A TRUE OFF AND ON SWITCH. NEVER REMOVE THE
CABINET UNLESS THE UNIT HAS BEEN COMPLETELY DISCONNECTED
FROM AC POWER.
6.1
First Time Operation Using Factory Default Settings
The following procedure is a simple functional check using the unit as a VGA
Scaler to verify correct operation in the Factory Default configuration. Please
perform this check immediately after unpacking the unit and once you have
verified all the required accessories are present. In order to carry out this
setup you will need a Personal Computer as a signal source and its computer
monitor.
First, connect the AC power cable to the unit. (Refer to the diagram below.
The cable connects to the socket labeled “Power 100v – 240v 47-63Hz – 1.2A
Max”).
Next, disconnect the cable going from the Monitor to the PC. Connect the
output from the PC video card (the PC connector formerly used by the monitor
cable) to the input labeled “RGB1” on the rear panel of the Scaler.
Finally, connect the cable from the monitor to the connector labeled “RGB
Output” on the Scaler. Connect the AC Power Cable to a working AC outlet
and turn on the PC, monitor and the Scaler.
Provided you have not changed anything from the Factory Defaults, after a
few seconds to initialize, the CORIO2 logo will appear on the output monitor.
You will then need to select the RGB1 input on the Scaler as a signal source.
Summary of Contents for C2-4000 Series
