C2-4000 Series RGB Scaler Operation Manual
102
21.2.2 The image is shifted and not fully viewable
There are several ways to correct this, depending on the actual problem.
First adjust the output H/V shift value in the Output parameters menu until the
white border that is displayed is centered on the Scaler output. Next adjust the
TL pos. adj. values in the Setup Program source menu until the incoming
video signal is displayed correctly in the white-bordered box. You may also
need to adjust the BR size adj. setting to insure the incoming video signal is
properly displayed.
21.2.3 The output resolutions no longer appear as expected.
Because any changes made in the Image parameters menu are automatically
stored, it may be that the resolution data has become altered beyond the
parameters of a new piece of equipment. Either manually correct the
resolution data, or restore the data to factory conditions by doing a Firmware
Update. The user should avoid altering the Image parameter data unless
absolutely necessary.
21.2.4 The Output image is distorted.
This may occur where some of the areas of the image are very dark and
others are very bright. The solution is to adjust the contrast and brightness
settings on your Output device to rectify the problem.
21.2.5 I can no longer adjust the Output image resolution.
When the unit is in Lock mode, the output resolution is fixed to be the same
as the Lock source input resolution. During this time the Output image menu
item is not adjustable.
21.2.6 There is no picture on the preview output.
Because the preview output is an unscaled output, insure that the connected
output device is capable of showing the resolution on the currently selected
preview input. Also note that if previewing a CV or YC source, you will need to
connect to the CV Preview and not the RGB Preview.
21.2.7 The picture on the video display is green.
The Output image type is probably set to YUV mode, whereas you are
connecting to an RGB monitor.
21.2.8 The RGB input is selected but the image is rolling or pink.
Check the input setup and confirm that the input type and sync method is set
correctly. (Having YUV input selected, instead of RGBHV often causes this
problem).
Summary of Contents for C2-4000 Series
