[Pile length] (Unit: mm) *2
a
．
When the pile length signals are com-
posed of indexes (0) to (7)
・
The pile lengths set for [0] to [7] are used
for weaving.
・
The value set for [L1-L2 (0-7)] is added to
the L2 pile length.
・
Faulty pile formation can be prevented by
providing a deviation between L1 and L2.
b
．
When the wave signals are composed of
indexes (8) to (15), refer to the follow-
ing:
・
A ( 8) : Pile length set for [Pile length
(A)] (hereinafter referred to as Pile A
length)
・
A
+
( 9) :Pile length calculated by adding
[Step length (A)] to Pile A length
・
A- (10) :Pile length calculated by sub-
tracting [Step length (A)] from Pile A
length
・
A* (11) :Pile A length
・
B (12) :Pile length set for [Pile length (B)]
(hereinafter referred to as Pile B length)
・
B
+
(13) : Pile length calculated by adding
[Step length (B)] to Pile B length
・
B- (14) :Pile length calculated by subtract-
ing [Step length (B)] from Pile B length
・
B* (15) : Pile B length
A trapezoid-shaped wave towel can be
woven in the way shown below: Taking A as
a reference, operate the loom in A
+
mode for
a while, in A* mode for a while to form the
top, and then in A- mode for a while. Each
value set for [L1-L2(A)] and [L1-L2(B)] is
added to the L2 pile length for A and B
respectively.
[Pile ratio] *2
All pile lengths are adjusted in s set ratio.
E4.
Instrumentation and Electronic Jacquard for Towel Weaving Machine
81
