(5) [Flange installation on the side of the counteryarn
beam gear]
Mark the yarn beam 1 at a point the reed drawing
width of L mm to the right of the marking made in
(1).
NOTE
: A minimum effective drawing width to
each nominal reed width is a nominal
reed width minus 70 cm.
(6) Screw in the yarn beam flange 3 from direction B.
Match the marking made in (5) to the inside of
yarn beam flange 3.
・
For the ease of screwing, apply grease or oil to
the threaded portion.
(7) Screw in the flange ring 5 also from direction B.
Match the bolt holes of the yarn beam flange 3
and flange ring 5 by providing a clearance of 3 to
5 mm between the end faces of the yarn beam
flange 3 and flange ring 5 and tighten the bolts.
M1. Preparation for Setting
2
