[1.2] Pile beam installation
1) [Mounting a yarn beam gear side]
(1) Standard case (using a flange ring)
(1) Make a mark on 110 mm away from the side a
of yarn beam 1 with a felt pen or something
similar.
(2) Screw-in yarn beam flange 2 from the direction
of "A" until the flange's inside becomes aligned
with the mark made in step (1). For making the
screwing-in job easier, apply grease or oil to
the threaded section.
Note:
The dimension of X mentioned above
represents the reference dimension.
Fine adjustment should be conducted
depending on your fabric.
(3) Screw-in ring 5 onto yarn beam 1, and set yarn
beam flange 2 with three fixing bolts (82101-
10035).
(4) Set yarn beam gear 4 onto yarn beam 1 so that
the holes (eight large holes) provided in yarn
beam gear 4 become aligned with those in yarn
beam 1. Then, tighten yarn beam 1 and yarn
beam gear 4 with eight bolt 8 to align the bolt
holes of yarn beam gear 4.
M1. Preparation for Setting
3
