[3] Vertical Position of the Temple
(1) Adjust the height of the left- and right-hand temples
with the number of the shims 1 between a temple
bracket 2 and the temple base 3.
Adjust the number of shims by loosening 8 bolts on
the left-hand side and 6 bolts on the right-hand side.
The standard number of shim is one shim of 1 mm.
(2) It is necessary to have a right-hand side cutter shaft
bracket 4 at the same height with the temple base 3.
Insert the same number of shims inserted between
the cutter shaft bracket 4 and the temple base 3 in
(1).
To adjust, loosen the bolts 5 (2 bolts).
The standard number of shim is one shim of 1 mm.
[4] Standard Setting of the Temple Ring
Loosen the bolt 2 to turn the temple ring 1 so as to have a
marked line x to the top. Tighten the bolt 2 to fix the
temple ring.
・
To provide the temple with a harder pull, set the
marked line x to the counter-reed side.
NOTE
: Care should be taken, however, since loose
warp will result if the end of the fabric falls
from the end of the temple.
・
To weaken the temple pull, set the marked line x to the
side of the reed.
M3. Temple
16
