Toshiba Strata DK 24, Installation And Maintenance Manual

Page: 156 / 372

INSTALLATION-TELEPHONE
SECTION 400-096-207
SEPTEMBER 1992
7-10
3) Reinstall the telephone base, and secure it
with its four captive screws.
3.50 Beep Strap
3.51 A "beep" sounds whenever a dialpad button
or feature button is pressed on a digital telephone.
To eliminate this beep follow the procedure below:
1) Loosen the four captive screws securing the
telephone base (Figure 7-1), and remove the
base.
NOTE:
Although Figure 7-1 specifically illustrates
how to remove an electronic telephone base,
it also applies to digital telephones.
2A) For 2000-series digital telephones, refer to
Figures 7-7 or 7-8, and cut the BEEP strap.
2B) For 1000-series digital telephones, refer to
Figure 7-9, and cut the BEEP strap.
3) Reinstall the telephone base, and secure it
with its four captive screws.
3.60 Microphone/Speaker Sensitivity Adjust-
ment (Speakerphones Only)
3.61 High ambient noise levels may cause the
speaker on some digital telephone speakerphone
models to cut off frequently. To prevent this for the
1000-series digital telephone models, perform the
following procedure to make the telephones less
sensitive to the noise: (The 2000-series Tele-
phones are adjusted per the instructions in the
Note after the procedure.)
1) Loosen the four captive screws securing the
1000-series Digital Telephone speakerphone
base (Figure 7-1), and remove the base.
NOTE:
Although Figure 7-1 specifically illustrates
how to remove an electronic telephone base,
it also applies to digital telephones.
2) For the 1000-series speakerphone model
(DKT1020-SD), refer to Figure 7-9, and lo-
cate the ROOM NOISE switch. Push the
switch carefully to the H (high) position (for
low sensitivity) when there is high background
noise in the area surrounding the telephone.
3) Reinstall the telephone base, and secure it
with its four captive screws.
NOTES:
1. To make the 2000-series Digital Tele-
phone speakerphone models less sensi-
tive to loud surrounding noise, hold down
Mic button, then press the up Vol button.
The less-sensitive level will be set after
the third flash of the Mic LED. To reset the
sensitivity back to the normal level, hold
down the
Mic button
, then press the down
Vol button. The normal level will be set
after the third flash of the Mic LED.
2. On 2000-series Digital Telephone speak-
erphone models that are set for low sen-
sitivity, the Mic LED will flash at the in-use
rate when using the speakerphone. When
set to normal sensitivity, the Mic LED will
be on steady when using the speaker-
phone.
3.70 Busy Override and Camp-on Ring Tone
over Handset Option
3.71 The Busy Override and Camp-on Ring tones
can be sent over the telephone handset or head-
set, in addition to the speaker, with 2000-series
digital telephones. The tones only sound over the
speaker with 1000-series Digital Telephones. Per-
form the following procedure to have these tones
sent over the handset of the DKT2010-H model:
(For the DKT2010-SD, the DKT2020-S, and the
DKT2020-SD models, see the Note following the
procedure.)
1) Loosen the four captive screws securing the
telephone base (Figure 7-1), and remove the
base.
NOTE:
Although Figure 7-1 specifically illustrates
how to remove an electronic telephone base,
it also applies to digital telephones.