Toshiba Strata DK 24, Installation And Maintenance Manual

Page: 323 / 372

-19-
REMOTE ADMINISTRATION & MAINTENANCE PROCEDURES
SECTION 400-096-600
SEPTEMBER 1992
TABLE RM-J
TYPE 1 PROGRAM PROCEDURE EXAMPLE
ACTION STEP DISPLAY/PRINTOUT
1
>MODE PROG
P
Enter Program Mode
At the >MODE prompt, enter
P R O G CR .
2
P 10
P10
Enter Program Number
Refer to the record sheet and enter the desired program number.
Example: Program 10-1, enter
1 0 , press CR .
3
P10 1
Enter Program Code or Digit(s) Per Record Sheet
1 or other digit required.
4
P10 1 01 N
Enter Button/LED Number
Enter the desired button/LED number.
Example: Button/LED 01, enter
0 1 .
5
P10 1 01 N Y
To Change Button/LED Status
Refer to the System Record Sheet and change the button/LED
status, if required (Y or N).
Example: Enter
Y .
6
(PROGRAMS: 10-1, 10-2, 10-3, 15, 16, 42-0, 77-1, 77-2)
NOTE: Most programs do not require a second digit.
P10 1 01 Y-
7
To Advance to Next Button/LED
Press
SPACE . Repeat Step 5 if necessary.
P10 1 01 Y
02 N
8
To Exit Program/Store Data
A)
B)
P10
P10 ##
P
To exit this program, press # # , then press CR .
Continue returning to Step 2 until all Type 1 programs
are completed.
To Store Data of Button/LED Status Change
Enter
CR .
Reenter Steps 3 and 4.
NOTE: This step is optional and not required to save data.
(see Note)
9
10
To Exit the Program Mode
Press
# # CR .
> MODE
To Enter Another Mode
Press
D U M P CR (data dump)
T E S T CR (test)
M E S G CR (LCD messages)
R E P T CR (speed dial)
D
T
R
(no prompt)
Button/LED Number
Program Code
Program Number
NOTE:
Y = button/LED "ON", N = button/LED "OFF"
Buttton/LED "ON"