Toshiba Strata DK 24, Installation And Maintenance Manual

Page: 364 / 372

-60-
REMOTE ADMINISTRATION & MAINTENANCE PROCEDURES
SECTION 400-096-600
SEPTEMBER 1992
NOTES:
1. Press m at any time to start over.
2. [M] represents the message entered.
3. With Release 2 software only, remote called station messaging is not available from electronic telephones, but it is
available from ASCII terminals connected to the TTY port or via IMDU on the PIOU or PIOUS.
TABLE RM-BN
MODE 94
REMOTE CALLED STATION MESSAGING (ADD/REVIEW/CHANGE)
ACTION STEP DISPLAY/PRINTOUT
1
>MODE MESG
Enter the Message Mode
At the >MODE prompt, enter
M E S G CR .
2
m 94
To Add Or Review a Called Station Message
3
Set the terminal keyboard to the lower case (cap lock off) and
enter
m 9 4 .
4 Enter p Y Y Y (p = page command [lower case] and
Y Y Y = originating station number).
m94 XXX
m94 XXX p YYY
5 Enter p (p = page command [lower case] and
= 2-digit message memory location: 10 ~ 19 personal
messages and 60 ~ 99 = system messages).
After
p is entered, the previously stored message (M) is
6 To Change the Message (M+)
7 To Set Message
8 To Exit the Message Mode
m 0
q
>MODE
Enter X X X (XXX = Destination station number or destination
group number [30 = all stations, 31-34 per system,
displayed. (If there is no stored message, nothing is displayed.)
m94 XXX p YYY p [M]
Set the terminal keyboard to upper case and change message
as required (alphanumeric, 32 characters max. for total message).
m94 XXX p YYY p [M+]
m94 XXX p YYY p [M+] p
m 0
Set the terminal keyboard to lower case and enter p m 0 .
Destination station: Msg (MESSAGE) LED flashes, “CALL YYYM”
is displayed.
Origination station: “SENT XXXM” is displayed.
At any time, enter m 0 q (lower case).
Program 31]).
Zero