Toshiba Strata DK 24, Installation And Maintenance Manual

Page: 328 / 372

REMOTE ADMINISTRATION & MAINTENANCE PROCEDURES
SECTION 400-096-600
SEPTEMBER 1992
-24-
TABLE RM-P
PROGRAM 12
SYSTEM ASSIGNMENTS – BASIC TIMING
ACTION STEP DISPLAY/PRINTOUT
1
>MODE PROG
P
Enter the Program Mode
At the >MODE prompt, enter
P R O G CR .
2
P 12
P12
Enter Program Number 12
3
P12 3 1
Check the record sheet and enter the program code that is
required.
As an example, feature 3, enter
3 .
The present selection will be displayed.
Press CR .
4
P12 3 1 2
Refer to the record sheet and change if required.
As an example, change it to 2.
Enter
2 .
5
P12
P12 # #
P
To Exit Program/Store Data
A)
B)
C)
To store data, press CR .
Continue returning to Step 3 until all Program 12 data is
entered.
To exit this program, press
# # CR .
TABLE RM-Q
PROGRAM 13
DEFINING THE MESSAGE CENTER
ACTION STEP DISPLAY/PRINTOUT
1
>MODE PROG
P
Enter the Program Mode
At the >MODE prompt, enter
P R O G CR .
2
P 13
P13
Enter Program Number 13
3
P13
P13 1 NN
Enter the number 1 . The present port number will be displayed.
Refer to the record sheet and enter the required port number.
Example: Port 00, enter
0 0 CR
.
4
P13 1 NN 00
P13
P13 ##
P
Press # # CR .
5 To Exit this Program
Press CR .
NOTES:
1. A blank is displayed by “N”.
2. Programs 15 and 16, use Type 1 procedure, and Program 17, use Type 2 procedure.