Toshiba Strata CTX, Programming Manual, Page: 71 / 533

System
104 System Timer
Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03
4-11
Sy
stem
08 Call Forward No Ans
Time The System Call Forward No Answer timer specifies the time period that a phone
will ring prior to invoking the Call Forward operation.
Possible values: 1~180 sec. (default = 30)
09 Dial Input Timer This timer permits dial input for a telephone and trunk using DTMF.
Possible values: 0~60 sec. (default = 20)
10 Delay 1 Ringing Timer This timer specifies the time to wait before applying ringing to the designated
phones.
Possible values: 1~60 sec. (default = 12)
11 Delay 2 Ringing Timer Select the time to wait before applying ringing to the designated phones.
Possible values: 1~60 sec. (default = 24)
12 Door Unlock Timer Select the length of time to send an electrical signal to a door for releasing the lock.
Possible values: 1~30 sec. (default = 6)
13 9+11 Judgement Timer The 9+11 Inter-digital timer provides a timing value (1~30 seconds) for the system
to wait for additional digits to be dialed looking for the 911 or 9+911 dialed codes
for treatment using the E911 procedures rather than normal dialing treatment.
Possible values: 1~30 sec. (default = 5)
14 Emergency Call Timer The Emergency Call timer sets a time for advancing the call to the next station in a
list of destinations for the call.
Possible values: 10~180 sec. (default = 30)
15 ABR Busy Detection
Time The Destination Busy Detection timer sets the time to wait while looking for a busy
condition on an external call. If detected, it will trigger the initiation of the Automatic
Busy Redial cycle.
Possible values: 1~30 sec. (default = 5)
16 Lost Call Timer The Lost Call timer sets the time that a failed transfer recall will ring on the
originating station prior to attempting to recall a secondary location.
Possible values: 1~600 sec. (default = 180)
17 Lost Call Final Timer The Lost Call Final timer sets the time that a failed transfer recall will ring on the
secondary location before being automatically disconnected.
Possible values: 1~600 sec. (default = 30)
18 DTMF Tone Sending
Time The DTMF tone sending duration for dialing on CO Lines.
Possible values: 80msec (default) or 160msec
19 Auto Disconnect Time after which an unsupervised trunk may be automatically released.
Possible values: 0~60 min. (default = 0)
23 System Timer Network
DSS Refresh Timer This parameter is available only with CTX Release 1.3 or higher software and with
CTX WinAdmin Release 1.3 or higher software.
Possible values: 20~180 seconds (default = 30)
F
IELD
D
ESCRIPTION