Toshiba Strata CTX, Programming Manual, Page: 284 / 533

Telephone Button Programming
Button Programming Examples
13-6
Strata CTX Programming - Part 3:Telephone Button Programming 04/03
Program 204
Reference “Program 204” on page 13-33 and review Summary column field descriptions. This program
enables you to setup the DKT parameters.
1. Enter programming mode. See “ Step 1: Enter Program Mode on page 13-7 ."
2. At the
PROG=
prompt enter and press
+ROG
.
3. At the DN= prompt enter (n) and press
+ROG
.
4. Press
)%
. Press to select a Extension and press
+ROG
.
5. Press
)%
. Press to select Pattern 3 for this DKT and press
+ROG
.
For this example, we are using a 20-button DKT. There are three button patterns to choose from for
each type of digital telephone.
Only the above
)%
s need to be assigned. Press
+ROG
again before proceeding to the next step.
6. Press
+ROG
to return to the PROG= prompt.
Note Additional assignments can be made to fine tune DKT parameters. See Summary column for field
descriptions and default values. If specific assignments are not made, the system automatically
assigns the default value.
Program 205
Reference “Program 205” on page 13-37 and “Feature/Button Code Parameter Assignments” on
page 13-39 . This program assigns features and parameters to the FB buttons on your DKT telephone. In
this example, the
)%
button on your DKT will be programmed to act as a GCO button.
1. Enter programming mode. See “ Step 1: Enter Program Mode on page 13-7 ."
2. At the PROG= prompt enter and press
+ROG
.
3. At the
DN=
prompt enter (n) and press
+ROG
.
4. Press
)%
. Enter to assign a GCO and press
6SNU
.
To select the n1, n2, n3, n4 and n5 values required in “Program 205” on page 13-37 , see “GCO” in the
table titled “Feature/Button Code Parameter Assignments” on page 13-39 .
5. Enter to assign a GCO number and press
6SNU
.
6. Enter to assign a GCO index and press
6SNU
.
7. Enter to enable immediate ringing for this GCO and press
6SNU
.
8. Enter to assign a soft ring tone to this GCO and press
6SNU
.
9. Enter to assign an Owner DN to this GCO number and press
+ROG
twice.
10.Press
+ROG
to return to the PROG= prompt.
Note Press
+ROG
again to exit Button Programming Mode.
Program 208
Reference “Program 208” on page 13-44 . This program assigns timing parameters to Primary DNs.
1. Enter programming mode. See “ Step 1: Enter Program Mode on page 13-7 ."
2. At the
PROG=
prompt enter and press
+ROG
.
3. At the DN= prompt enter (n) and press
+ROG
.
4. Press
)%
. Press to set the number of ABR attempts and press
+ROG
.