Toshiba Strata CTX, Programming Manual, Page: 28 / 533

Strata CTX Programming Guidelines
Step 2: Plan Your System Requirements
1-8
Strata CTX Programming - Part 1: Getting Started 04/03
Default Feature Access Codes
Refer to “102 Flexible Access Codes” on page 4-3 .
Note For DKTs, assign only the PDN numbers. Do not program any other Flexible Buttons or features in
to the phones. Strata CTX automatically recognizes and sets up digital telephone stations.
Step 2: Plan Your System Requirements
Plan for your Strata CTX system requirements in detail before beginning your installation. Use record
sheets wherever they are provided to document your installation requirements. The following are some
areas to consider:
• Flexible Numbering Plan (102) – Planning your Flexible Numbering requirements is essential to a
smooth installation. Trunk group access and station range requirements are especially important areas
of consideration.
• COS (103) – Determine the Class of Service (COS) requirements for your station and trunk groups.
There are up to 32 possible COS plans.
• DRL (111) – Define up to 16 Destination Restriction Level (DRL) assignments.
Important! Destination Restriction is an expanded feature of what has traditionally been known as Toll
Restriction. Toll Restriction is only one facet of Strata CTX’s Destination Restriction feature.
Refer to Destination Restriction in this manual when programming Toll Restriction
requirements.
• FRL and QPL (506) – Define up to 16 Facilities Restriction Level (FRL) and Queuing Priority Level
(QPL) assignments.
Step 3: Program CTX for First Time
Follow the steps below to program the Strata CTX for the first time. Following this initial setup procedure
enables you to perform a standard Strata CTX setup with common System and Station default assignments.
Toshiba recommends adherence to these procedures for initial setup.
1. Card Assignments (100) – Choose System > Card Assignment. It is not necessary to physically install
PCBs prior to programming Strata CTX.
If you physically install your PCBs prior to initial setup, CTX WinAdmin automatically recognizes
PDKU, BDKU/BDKS, RSTU, RCOU/RCOS and RGLU PCBs and assigns default stations and trunks
automatically. All other PCBs are assigned manually. See
“100 Cabinet Slot PCB Assignments” on
page 4-1 for more details.
2. ILG Assignment (304) – Choose Trunk > ILG to assign Incoming Line Groups (ILG). See “304
Incoming Line Group Assignment” on page 6-2 for more details. ILGs enable line groupings of shared
Class of Service features for incoming call handling.
3. OLG Assignment (306) – Choose Trunk > OLG to assign Outgoing Line Groups (OLG). See “306
Outgoing Line Groups” on page 6-4 for more details.