Toshiba Strata CTX, Programming Manual

Page: 52 / 533

Installation
Step 3: Set up Modem Connection
3-10
Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03
Step 3: Set up Modem Connection
Step 3A: Connect CTX WinAdmin PC to Strata CTX Modem
Connect an RJ11 cable from your PC modem to an active phone line or RSTU port. See Figure 3-4 .
Figure 3-4 CTX WinAdmin Modem Interface Connection
CTX WinAdmin PC Modem to CTX Modem Call Setup – CTX Programming and Operation
• Direct ring connection over CO lines
• DID lines: in PRG 309, assign “Built-in Modem” as the Audio Day1, Day, and/or Night destination
type.
• DIT ground/loop start lines: in PRG 310 assign “Built-in Modem” as the Day1, Day2, and/or Night
destination type.
• Direct Ring when connected to RSTU or DISA line: put “#19” in CTX WinAdmin Phone Number
dial string.
• Transfer a CTX WinAdmin call to the Strata CTX modem from a CTX Auto Attendant or telephone
After receiving the call from the CTX WinAdmin user, press
&QI7UQ
or hook flash and dial #19 then
hang up after receiving CTX modem tone.
Note If calling an Auto Attendant put “xxxxxxx,,,,,,,, #19” in CTX WinAdmin Phone Number dial string.
Where “xxxxxxx” is the site phone number and each “,” adds a three-second delay before dialing
#19 to connect to the modem.
Important! Windows XP: Choose Step 3B; Windows 2000: Choose Step 3C.
Flash
or ROM
and
RAM
CO Line
Circuit
Strata CTX
33.6 kbps v.34
Point-to-point TCP/IP
Dial #19
Time
Switch
Modem
RS-232 Cable
RS-232 Cable
Remote CTX
WinAdmin PC
CO Line CO Line
Telephone
Network
5592
Local CTX
WinAdmin PC
Modem
BECU or
ACTU/
AMDS
Modem
RSTU