RemotEye III User Manual – 62330-005
75
Figure 40: EMD Gray Web Status (Unknown)
The EMD provides the measurements for room (ambient) temperature, room (ambient) humidity, and two alarms
(two dry contacts). The warning/critical thresholds can be setup via the "EMD Setup" page.
The table Comprehensive View shows the following parameters:
EMD Name - This field displays the EMD Status as followed:
•
“EMD-HT” – When the EMD is connected and working correctly.
“Disable” – Whenever the EMD is connected but the “Device Status” is disabled in the EMD configuration settings
(See “
•
EMD Configuration” in page 75).
•
“Unknown” – Whenever the EMD is not connected to the RemotEye III.
EMD Temperature (
°
C) - This field displays the temperature in Celsius degrees.
EMD Humidity (%) - This field displays the humidity in %.
EMD Alarm-1 - This field displays the Alarm-1 status.
EMD Alarm-2 - This field displays the Alarm-2 status.
EMD Configuration
This page allows administrator to configure all necessary parameters/settings of an EMD.
Sensors
The sensors column parameters consist of the following:
1.
Temperature (°C)
2.
Humidity (%)
3.
Alarm-1 (Sec)
4.
Alarm-2 (Sec)
5.
Device Status
Set Point (Low)
The low threshold(s) at which the sensor (temperature or humidity) will trigger an alarm(s). The EMD can be
configured to activate at two set points on the low limit Warning, and Critical. If the checkbox is not filled, the
threshold is disabled and the alarm will not be triggered. The valid range for the Temperature threshold setting is 5
°
C
to 65
°
C, and for Humidity threshold setting is 5% to 95%.
Summary of Contents for RemotEye III
Page 1: ... ...
Page 117: ...116 RemotEye III User Manual 62330 005 Figure 62 RemotEye Save Log Utility Set Page ...
Page 166: ......
