18
RemotEye III User Manual – 62330-005
Making the Network Connection
Each Ethernet network is different. Therefore, the following steps should be used as an outline for connecting the
RemotEye III to a network (See Figure 13: Network Connection Example):
1.
Connect one end of a Category 5 cable to the NETWORK RJ45 receptacle of RemotEye III.
2.
Connect the other end of the Category 5 cable to a designated network switch, hub, or computer. A
network administrator will need allocate an available port/IP address.
3.
Verify a network link has been established. Confirm the left-most green LED is illuminated for 100Mbit/s
or right-most amber LED is illuminated for 10Mbit/s.
Note: The RemotEye III’s “DHCP/BOOTP” setting comes enable by default. If there is a DHCP/BOOTP server
within the network, the DHCP/BOOTP server will allocate (lease) an IP address to the RemotEye III.
This setting has to be disabled if using static IP address by going to “RemotEye III Management”
“RemotEye III Control” on its web interface.
Cat5
Cable
Figure 13: Network Connection Example
Summary of Contents for RemotEye III
Page 1: ... ...
Page 117: ...116 RemotEye III User Manual 62330 005 Figure 62 RemotEye Save Log Utility Set Page ...
Page 166: ......