Thermo Scientific Micro-Tech 9101, Reference Manual

Page: 230 / 329

B-58 Micro-Tech 9101/9201 Reference Manual, Rev J Thermo Fisher Scientific
4. The display shows a “running” message (shown below) while the
records are being printed.
Here is the Print menu table.
No. Parameter Selection Description
1 Handshaking none, xon-xoff, CTS Refer to the printer instruction manual to
define which selection is required.
The selection None is only used for
testing purposes. It is not recommended
for normal use. If None is selected, the
system is not able to recognize whether
or not the printer is on-line, or if the paper
is empty.
The most commonly used protocol is
CTS, which is a signal generated by the
printer to indicate whether it is ready to
receive data.
(Password: Service.)
2 End of line CR+LF, CR, LF Different printers use different end of line
patterns. Select the one you need for your
printer. (Password: Service.)
3 Delay end of line 0 (0 - 5 sec) Some printers cannot accept characters
while they are printing. In some cases, the
handshake is not well controlled by the
printer, so a delay at end of line is helpful.
(Password: Service.)
4 Form Feed no, yes A form feed character can be sent to the
printer after each report to force the
printer to eject the paper. If NO is
selected, a normal End of Line
character(s) is printed at the end of the
report. (Password: Service.)
5 Print interval 0 (0-59 min)
0 (0-23 hours)
0 (0-365 days) This feature repeatedly prints a Total
report to the serial printer at the specified
time interval.
BATCH
PRINTER SCROLL
Com # 1 is running
Print SET UP
READY ALARM CALIB
PRINT COM